Oil cylinder is a container for storing and transporting liquid or gas. After a period of use, dirt and sediment will form,

Repairing and cleaning the oil cylinder is an important measure to ensure its normal operation and extend its service life.

The trimming and cleaning steps of the oil cylinder will be described below.

1、 Preparatory work

1. Understand the structure and working principle of the oil cylinder, and timely understand the use and maintenance requirements of the oil cylinder.

2. Determine the cleaning time and method, and try to carry out it during the shutdown or shutdown period, so as not to affect the production and work process.

3. Provide necessary tools and cleaning equipment, such as detergent, brush, high-pressure water gun, etc.

4. Wear personal protective equipment, such as gloves, goggles, protective clothing, etc.

2、 Trimming and cleaning steps of oil cylinder

1. Drain the liquid or gas in the cylinder and release its pressure to zero.

2. Close all inlet and outlet valves of the oil cylinder and disconnect the pipes connected with them.

3. To clean the outside of the oil cylinder, use detergent and clean water to coat the surface of the oil cylinder. Then rinse with clean water.

4. Use a high-pressure water gun to clean the inside of the oil cylinder, and try to wash away the dirt in the oil cylinder.

5. Note that the nozzle must be placed at the center of the oil cylinder during cleaning to avoid damaging the inner wall of the oil cylinder.

6. After confirming that there are no impurities left in the oil cylinder, more thorough cleaning can be carried out.

7. Brush the inner wall of the oil cylinder with cleaning agent to ensure that the dirt and sediment are removed. Then rinse again with clean water.

8. Check whether the inner wall and interface of the oil cylinder are rusted, corroded or damaged. If necessary, repair or replace them in time.

9. After cleaning, evaporate the water on the inner surface of the oil cylinder or discharge it through the vent.

10. Visually inspect the oil cylinder to ensure that there is no potential safety hazard such as damage and leakage outside.

11. Lubrication and maintenance shall be carried out in time according to the service condition of the oil cylinder to extend the service life of the oil cylinder.

3、 Precautions

1. Pay attention to the safety of operators during cleaning.

2. Follow relevant safety operation procedures, wear personal protective equipment, and ensure the normal use of cleaning equipment and tools.

3. Before cleaning, you should first understand the characteristics and use methods of the detergent used, and prepare and use it according to the correct proportion.

4. Pay attention to avoid environmental pollution during cleaning. The use of environmentally friendly cleaning agents and the correct disposal of waste liquid are important links to reduce environmental pollution.

5. After cleaning, clean the work site in time, and properly dispose of waste materials and sewage to ensure the cleanness and safety of the workplace.

in summary, Oil cylinder manufacturer The steps of trimming and cleaning the oil cylinder mainly include preparation, trimming and cleaning the oil cylinder and precautions. Correct trimming and cleaning operation of oil cylinder can ensure normal operation of oil cylinder and prolong its service life, thus improving production efficiency and safety.