Paver Hydraulic cylinder It is one of the pavers and its important accessories.

When using the hydraulic cylinder, we all know that we should always pay attention to its working state and keep it running smoothly.

The hydraulic oil has an important influence on the operation of the hydraulic cylinder.

Therefore, it is an important job to select the proper hydraulic oil, and we hope that users will pay attention to it.

Many users may not understand this point very well. Therefore, we hope that through this introduction, we can make it easier for you to choose hydraulic oil in the future.

So, how should we choose the proper hydraulic oil when using the hydraulic cylinder in order to make it run normally as far as possible?

1. When using hydraulic cylinders, we should choose good hydraulic oil,

2. Corresponding hydraulic oil products shall be selected according to relevant standards to avoid some accidents that may occur.

3. Note that many factors should be considered in the selection process, For example, the climate conditions in the working area should be selected according to the local bottom temperature.

4. After selection, appropriate amount of oil should be injected.

5. Pay attention to the cleanliness of the hydraulic system, and arrange personnel to check it regularly,

6. When it is found that the oil is deteriorated or polluted, it should be replaced in time.

7. If the oil level drops, it shall be supplemented in time.

8. When some problems are found, they should be checked and repaired in time. After maintenance, the hydraulic cylinder should be allowed to run steadily for a period of time.

9. Then, when selecting hydraulic oil for the hydraulic cylinder, pay attention to its quality,

10. The main factors to be considered are: whether the viscosity of the hydraulic oil is correct, whether the texture is clean,

11. Whether the impurities contained in it will affect its normal use.

12. In fact, there are many factors that should be considered when selecting hydraulic oil,

13. We should select the appropriate hydraulic oil according to the specific situation, only in this way can we minimize accidents and let the hydraulic cylinder run normally.