Oil cylinder manufacturer Oil press maintenance system

1. Lubricate and maintain according to the lubrication requirements of the machine.

2. After each year of operation of the machine tool, the hydraulic oil shall be drained from the machine body oil tank for cleaning, and the filtered hydraulic oil shall be refilled. The oil volume shall be determined at 3/4 of the height of the oil pointer.

3. The oil filter screen on the oil suction pipe must be cleaned or washed regularly.

4. Regularly check whether the handle, knob and key are damaged.

5. The motor must be kept clean, and the air inlet grille of the motor must always be kept in a good ventilation state, without blocking.

6. Oil, lubricate and clean the machine tool 10 minutes before work every day.

7. Non operators are strictly prohibited to operate the equipment, and people must leave the machine and stop at ordinary times.

Safe Operation Procedures

1. The operator shall be familiar with the general performance and structure of the hydraulic press, and overload use is prohibited.

2. Before use, lubricate and refuel as required, and check the high-pressure pump Pressure gauge Whether various valves and sealing rings are normal.

3. Before starting the machine, check whether the mold is matched, whether the material weight meets the requirements, and whether the weighing tool is accurate.

4. When pressing, the mold must be placed in the center of the backing plate, and eccentric use is prohibited. Before starting each shift and after pressure test, check whether the mold is cracked.

5. In case of multi person operation, special personnel shall be assigned to start the machine and coordinate with each other.

6. It is forbidden to place hands and heads between the mold and the indenter.

7. After the work is completed, the pressing products, tools and molds shall be sorted out and placed in the designated place.